Change the presser foot to the button sewing
foot.
2. Position the work under the foot. Place the
button in the desired position, lower the
foot.
3. Select zig zag pattern. Adjust the stitch
width to "2.0-7.0" according to the distance
between the two holes of the button.
4. Turn the handwheel to check that the
needle goes cleanly into the left and right
holes of the button.
5. Before sewing, press the Auto-lock button
to sew reinforcement stitches automatically
at the beginning and at the end of the stitch.
If a shank is required, place a darning
needle on top of the button and sew.
6 For buttons with 4 holes, sew through the
front two holes first, push work forward and
then sew through the back two holes.
1. Move the drop feed control to " " to
lower the feed dogs.
.......
35
To Next Page
Loading...
