Silver Viscount 9500e - Replacing the Light Bulb; Bulb Replacement Procedure

69
Attention: Turn the power switch off and wait until the lamp has cooled down before
touching it.
1. Loosen the screw (a) on the left side of the
sewing head and remove the face plate (b).
2. If the machine is equipped with a 5W lamp,
replace the bulb as follows:
Pull light bulb downward to remove.
Replace the bulb with same type rated 5W.
Replace the face plate and tighten the
screw.
REPLACING THE LIGHT BULB
REPLACING THE LIGHT BULB
1
a
b
Please Note:
-
-
The 5W lamp is user-replaceable.
The 240mW LED lamp is not user-replaceable.
3
2
PUSH
3. If the machine is equipped with a 240mW
LED lamp, you must contact the manufacturer
or its service agent for repair in the event of
failure.
All manuals and user guides at all-guides.com