73
TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE
Seam
puckering
Patterns are
distorted
1.The needle thread tension is too tight.
2.The needle thread is not threaded
correctly.
3.The needle is too heavy for the fabric
being sewn.
4.The stitch length is too long for the
fabric.
5.The presser foot pressure is not
correctly adjusted.
1.The correct presser foot is not used.
2.The needle thread tension is too tight.
3.The stitch length is not suitable for the
fabric being sewn.
4.Feed balancing dial is not set properly.
1.Select the correct foot.
2.Loosen the thread tension .
3.Make stitch adjust.
4.Adjusting pattern balance.
1.Lossen the thread tension.
2.Rethread the machine.
3.Choose a needle to suit the thread and
fabric.
4.Make stitch dense.
5.Adjusting the presser foot pressure.
The sewing
machine
doesn't
operate
1.The machine is not turned on.
2.The Start/stop button was not pressed.
3.The presser foot lever is raised.
4.The Start/stop button was pressed,
even through the foot controller is
connected.
5.A thread is caught in the hook race.
1.Turn on the machine.
2.Press the Start/stop button.
3.Lower the presser foot lever.
4.Do not use Start/stop button when the
foot controller is con-nected. To use
Start/stop button, disconnect the foot
controller.
5.Remove the upper thread and bobbin
case, turn the handwheel backwards
and forwards by hand and remove the
thread remands.
The
machine
jams
Remove the upper thread and bobbin
case, turn the handwheel backwards
and forwards by hand and remove the
thread remands.
The
machine is
noisy
1.Fluff or oil have collected on the hook
or needle bar.
2.The needle is damaged.
1.Clean the hook and feed dog as
described.
2.Replace the needle.
Uneven
stitches,
uneven feed
1.Poor quality thread.
2.The bobbin case is threaded wrong.
3.Fabric has been pulled.
1.Select a better quality thread.
2.Remove the bobbin case, the thread
and reinsert correctly.
3.Do not pull on the fabric while sewing,
let it be taken up by the machine.
Problem
Cause
Correction Reference
4.Thread is caught in the hook.
3.Slight humming sound coming from
internal motor.
3.Normal
5.The feed dogs are packed with lint.
Remove the upper thread and bobbin
case, turn the handwheel backwards
and forwards by hand and remove the
thread remands.
1.Thread is caught in the hook.
2.The feed dogs are packed with lint.
6.Connect the power line plug to the
electric outlet.
6.The machine is not plugged in.
Page 20
Page 17
Page 12
Page 26
Page 74
Page 20
Page 26
Page 42
Page 70
Page 16
Page 11
--
Page 70
Page 12
Page 8
--
Page 23
Page 22
Page 23
Page 71
Page 8
Page 70
Page 10
To Next Page
Loading...
