■ 12
│
GB
│
IE
│
NI
SPBS 5000 A1
Charging with the USB cable
If there is no sunlight available, you can charge the battery of the
device with the USB cable
.
CAUTION
► Due to the high battery capacity and bearing in mind the
charging time, we recommend charging the power bank
using a USB mains adaptor (not supplied).
► Use only a USB mains adapter with an output voltage of
5 V and an output current of at least 2.1 A to charge the
power bank
■ To do this, connect the micro-USB plug of the charging cable
to the device’s micro-USB port
.
■ Connect the USB plug of the USB cable
to the USB connec-
tion of a USB mains adapter.
A rough estimate of the charge level is shown during charging by
means of the charge level LEDs
.
Charge level LEDs
Charge level
One LED is flashing < 25%
One LED is on, the second LED is flashing 25–49%
Two LEDs are on, the third LED is flashing 50–74%
Three LEDs are on, the fourth LED is flashing 75–99%
All LEDs are on 100%
To Next Page
Loading...
