SSP 2600 A1
GB
│
IE
│
NI
│
9 ■
♦ During the charging process, the current charge
level of the power bank is shown via the charge
level LEDs (see table in section "Checking the
charge level").
♦ To stop charging, disconnect the charging cable !
from the mobile device and the power bank.
The charging status LEDs go off after about
35 seconds.
Using the selfie stick
Before you use the selfie stick, you must first pair it with
your smartphone or compact camera via Bluetooth
®
.
This pairing creates a link between your smartphone or
your compact camera and the selfie stick.
NOTE
► Make sure that the battery of the power bank is
charged; otherwise the selfie stick will not work.
If necessary, charge the power bank battery
before using the selfie stick. Refer also to section
"Charging the power bank".
Connecting the selfie stick and smart-
phone/compact camera via Bluetooth
®
♦ Turn on your smartphone or compact camera and
activate the Bluetooth
®
function.
♦ Press and hold the On/Off button for about
2 seconds to activate the Bluetooth
®
function.
The Bluetooth
®
LED flashes for one minute.
The charging status LEDs light up and then go
off after about 35 seconds.
♦ Set the smartphone so that it scans for Bluetooth
®
devices. You will find a detailed description of
how to do this in the operating instructions for your
smartphone.
♦ Select SSP 2600 A1 from the list of found devices
on your smartphone to pair the two devices. The
Bluetooth
®
LED stops flashing when pairing
is successful.
♦ If you want to stop the Bluetooth
®
connection
with your selfie stick, for instance, to separate the
devices, press the On/Off button for 2 seconds.
The Bluetooth
®
LED flashes three times. The
charging status LEDs light up and then go off
after about 35 seconds. The Bluetooth
®
function
is now turned off.
To Next Page
Loading...
