Silvercrest 296789 - Cleaning the milk frother

GB
│
IE
│
NI
│
CY
│
17 ■
SEM 1100 B3
Cleaning the milk frother
CAUTION – PrOPErTy dAmAgE
■ NEVER use abrasive, corrosive or chemical agents to clean the appliance.
These could damage the outer surfaces of the appliance.
1) Place an empty container under the milk frother 0.
2) Immediately after use, turn the steam control 7 to the “+“ position and
allow the steam to escape for a few seconds.
3) Turn the steam control 7 off (as far as it will go in the direction “-“), switch
the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Pull the casing of the milk frother 0 off (Figure 1) and clean it thoroughly in
warm water.
6) Wipe the nozzle under the casing with a damp cloth. If necessary, add a little
mild detergent onto the cloth. After cleaning with detergent, always wipe off
with a cloth moistened with clean water. Ensure that there is no detergent
residue left on the nozzle.
7) Push the casing back onto the nozzle (Figure 1).
Figure 1