Silvercrest 296789 - Troubleshooting

■ 20
│
GB
│
IE
│
NI
│
CY
SEM 1100 B3
19) Push in the “Steam” button 4 so that it clicks into place.
20) Hold a container under the milk frother 0 and slowly turn the steam control
button 7 to the position “+ “ as soon as the green heating-up control lamp 5
lights up.
21) After about 1 minute, close the steam control 7 (turn it in the direction of the
“-“ as far as the stop), press the “Steam” button
4 again and switch off
the appliance.
NOTE
► If no button is pressed, the appliance turns off automatically after
30 minutes.
Troubleshooting
Malfunction Cause Solution
The espresso no longer
flows out.
• The espresso powder is too
moist and/or compressed
too tightly.
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder.
• No water in the water tank 9.
• Fill the water tank 9
with water.
• The holes of the sieve holder
openings are blocked.
• Clean the sieve holder u.
The espresso drips over
the edges of the sieve
holder u, not from the
openings.
• The sieve holder u is not
correctly inserted.
• Insert the sieve holder u
correctly.
• The sieve holder openings are
blocked.
• Clean the sieve holder u.
• There are espresso powder
residues on the edges of the
sieve holder u.
• Clean the espresso
powder residues from
the edges of the sieve
holder u.
The espresso is cold.
• The appliance was not
preheated.
• Preheat the appliance.
• The green heating-up control
lamp 5 has not yet glowed.
• Wait until the green
heating-up control
lamp 5 lights up.
• The cups were not pre-warmed. • Pre-warm the cups.
The pump is unusually
noisy.
• The water tank 9 is empty.
• Fill the water tank 9
with water.