19 GB/IE/NI
measurements with the date and time and request them
later on.
Configure the date, Bluetooth
®
and time as follows:
Insert the batteries, or press the SET button
6
for over
5 seconds for batteries that have already been inserted.
Configure the 12-hour or 24-hour mode using the +
7
button. Press the SET button
6
to confirm.
The year will flash.
Configure the year using the + button. Press the SET
button
6
to confirm.
The month will flash.
Configure the month using the + button. Press the SET
button
6
to confirm.
Configure the day, hour and minute consecutively as
described above. Press the SET
6
button to confirm
each entry.
The Bluetooth
®
symbol will be shown on the display.
„On“ or „Off“ will flash at the same time.
Using the function buttons „-/+“ choose whether you
want to activate („On“ flashes) or deactivate („Off
flashes“) Bluetooth
®
data transfer. Press the SET
button
6
to confirm.
If Bluetooth
®
is activated („On“) data transfer will begin
automatically after the measurement has been taken.
Note: The battery life is reduced by transfer via
Bluetooth
®
.
To Next Page
Loading...
