16 GB
front area of your nostril or ear. Remove the nose
or ear hair with small circular movements.
After using the product, switch the product off
by pushing the On / Off switch
6
towards the
marking “0”.
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning
agents. These might damage the surface of the
product.
Take the nose and ear hair trimmer attachment
3
off as shown in Fig. D and clean it carefully under
running water. Then fully dry the nose and ear
hair trimmer attachment
3
before re-installation.
Attention: The product is only protected against
splash water. Never immerse it in water. Otherwise,
irreparable damage may result.
If there are still hairs inside the nose and ear hair
trimmer attachment
3
, clean it with the a soft brush.
Occasionally place one or two drops of oil
onto the blade
4
and distribute the oil evenly
(see Fig. C).
Only use an acid-free oil suitable for electric
razor products.
To Next Page
Loading...
