Silvercrest 314863 - Page 17

■ 14
│
GB
│
IE
│
NI
│
CY SSMC 600 B1
■ If this does not remove the dirt, you can remove the lower plastic part of the
blender attachment 3 with the cutting blades 4 from the glass part of the
blender 3:
A
C
B
Fig. 4
A Glass part
B Sealing ring
C Plastic part with blades
1) Remove the blender 3 from the motor unit 6. For better stability, remove
the lid 2 by turning it anticlockwise towards position
(see Fig 1) until
you can pull it off upwards.
2) Turn the appliance upside down and turn the plastic part C of the
blender3 anticlockwise so that it can be detached from the glass part A
of the blender attachment 3 (see fig. 4).
3) Clean both parts in a mild soap solution or in the dishwasher.
4) You can carefully remove the sealing ring B from the plastic part C if
necessary. Clean in mild soapy water and rinse with clear water.
5) Dry all parts thoroughly before reassembling them.
6) If necessary, reinsert the sealing ring B into the plastic part C correctly.
Then place the plastic part C of the blender 3 back on the glass part A
of the blender 3 and turn the plastic part C clockwise.