Silvercrest 360503 2010 - Selecting the Speed Setting

■ 8
│
GB
│
IE
│
NI
│
CY SSMC 600 B1
Fig. 1 Fig. 2
5) Press the measuring cap 1 into the lid as far as the stop.
6) Place the completely filled and closed blender 3 with the handle to the
right on the motor block 6. Make sure that the arrow T on the blender 3
points to the S arrow on the motor block 6. Turn the blender 3 slightly
back and forth if it does not immediately sit properly. The motor cannot start
until the blender 3 is fitted flush to the motor unit.
Selecting the speed setting
Once the blender 3 is filled and sitting completely closed on the motor block 6,
you can switch on the appliance.
Set the switch 5 to …
■ Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■ Level 3 – 5
for more solid foods or for chopping
■ Level P (pulse function)
for short, powerful impulse operation, e.g. for crushing ice cubes or when
cleaning. To prevent overloading the motor, the switch 5 does not lock in this
position. Therefore, hold the switch 5 in this position for short periods only.
NOTE
► Fill the blender 3 with a maximum of 250 ml of ice cubes.
Otherwise, the ice cubes will not be crushed optimally.
IB_360503_SSMC600B1_GB_IE_NI_CY.indb 8 04.03.2021 14:05:26