EasyManua.ls Logo

Silvercrest EDS-SSM 600 D2 - General Safety Instructions

Silvercrest EDS-SSM 600 D2
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EDS-SSM 600 D2
GB
IE
NI
 3
Safety instructions
RISK OF ELECTRIC SHOCK
Connect the appliance only to mains power sockets supplying
a mains power voltage of 220 - 240 V
~
/ 50 Hz.
In event of operating malfunctions and before cleaning the
appliance, remove the plug from the mains power socket.
Do not expose the appliance to moisture and do not use it
outdoors.
If liquid gets into the housing, disconnect the appliance from
the mains power socket immediately and have it repaired by
a qualified technician.
Always pull on the plug to disconnect the appliance from the
mains; never pull on the power cable itself.
Do not kink or crush the power cable, and route the cable so
that it cannot be stepped on or tripped over.
To avoid risks, arrange for defective plugs and/or power
cables to be replaced at once by qualified technicians or our
Customer Service Department.
Do not attempt to open the hand blender’s motor casing. If
you do so, the safety of the appliance is no longer assured
and the warranty willa become void.
This appliance may be used by people with reduced physical,
sensory or mental capabilities or lack of experience and/or
knowledge if they are supervised and have been instructed
in how to use the appliance safely and have understood the
potential risks.
The appliance and its connecting cable must be kept away
from children.
Never immerse the motor unit in liquids, or allow liquids to
get into the motor unit housing.

Table of Contents

Related product manuals