36 US-EN
Press the button
7
on one of the
products which will then by default set it as
the „master“ unit. A beep will sound. When
pairing between both products has been
carried out successfully, the LED
5
of the
connected „slave“ unit stops flashing and a
sequence of beeps will sound.
The „master“ unit LED
5
will still be flashing
waiting to pair with the playback device.
Once the „master unit“ has successfully
paired with the playback device both the
„master“ and „slave“ units can be played
and controlled synchronously during
Bluetooth
®
playback mode.
Press the
button
7
again to break the
TWS pairing connection, the LED
5
on the
connected „slave“ unit flashes and a signal
tone sequence sounds.
To Next Page
Loading...
Need help?
General
