Setup
• Unfold the telescopic aerial and draw it out to its full length.
• Push out the support
if you wish to position the appliance at an angle.
Then turn the telescopic aerial
to a slanted upward angle.
Receive Mode
a) Switching the appliance on/off, button lock
• To switch the appliance on, press on the ...
– button “FM ON”
, if you wish to receive VHF transmissions.
– button “AM ON”
, if you wish to receive MW or SW 1-7 transmissions.
• The green LED “POWER”
glows for as long as the appliance is
switched on.
• To switch the appliance off, press the button “POWER OFF”
.
• With the sliding switch ”HOLD”
you can block all buttons against
adjustment (ON), or have them free for adjustment (OFF).
b) Adjusting the reception
• If you have switched the appliance on using the receiving mode button
“AM ON”
, first of all select either the reception range MW (Medium
Wave) or SW 1-7 (Short Wave). For this, push the waveband selector
into the relevant position.
• Then search for the desired radio station by slowly turning the tuning re-
gulator “TUNING”
until you have clear reception. In the display
the frequency just received is shown digitally, together with the unit
“MHz” (Megahertz) or “kHz” (Kilohertz).
- 7 -
To Next Page
Loading...
