Stop watch function
The stop watch function is only available when the radio is switched off.
• Press and hold down the
PAGE button for around 2 seconds, the screen
shows 00.00.0 U.
• Press
SNOOZE to start the stop watch. The maximum time for the stop
watch is 99 minutes and 59 seconds. If the stop watch exceeds the
maximum time, 99:59.0 is displayed and flashes.
• During time measurement, it can be stopped by pressing
SNOOZE.
• Pressing
SNOOZE again restarts the stop watch.
• Hold down
SNOOZE to reset the stop watch.
• Leave the stop watch by pressing
PAGE.
Countdown function
The countdown function is only available when the radio is switched off.
Set and save countdown
• Press and hold down the MEMORY SCAN button for around 2 seconds, the
screen shows D 00.00.
• Press the
UP or DOWN button to set the desired time.
5 countdown times are preset on the memory buttons and you can open
these directly using the corresponding memory button:
Button
M.0/5 10:00
Button
M.1/6 30:00
Button
M.2/7 45:00
Button
M.3/8 60:00
Button
M.4/9 90:00
• Press the
MEM button to save the set time, the memory space indicator MEM
flashes on the screen. Now use the M.0/5–M.4/9 buttons to select a memo-
ry space; when you press the relevant memory key the time is saved in this
memory space and the time previously stored there overwritten.
- 18 -
IB_KH2030_DT25841_LB3A_C 12.01.2009 16:50 Uhr Seite 18
To Next Page
Loading...
