- 6 -
Interaction with batteries
Leaking batteries can cause damage to
the radio alarm.
• If you do not intend to use the appli-
ance for an extended period, remove
the batteries.
• Should the batteries leak, clean the
battery compartment with a dry cloth
whilst wearing protective gloves.
Note:
Rechargable batteries cannot be
charged via the battery connection.
In the event of an extended power
cut (several hours), the clock and
alarm times must be checked and
possibly re-adjusted.
Assembly
Before operating the device, make sure
that it is in a faultfree condition. Do not use
it if it is not.
• Then insert the plug into the wall
power socket. Select a wall power
socket that is at all times easily
accessible so that the plug can be
easily withdrawn in the event of
a malfunction.
Setting the clock
If you are setting up the appliance for the
first time after inserting a new battery:
• Whilst holding the button TIME
r
pressed down:
• Press several times in succession, or
simply press and hold the button
HOUR
q
, to adjust the hour setting.
• Release the button HOUR
q
, as soon
as the desired hour setting appears in
the display
i
.
• Press several times in succession,
or simply press and hold the button
MIN
w
, to adjust the minute setting.
• Release the button MIN
w
as soon
as the desired minute setting appears
in the display
i
.
The adjusted time will be automatically
accepted as soon as the button TIME
r
is released.
Radio Reception
• Push the slider switch
o
into the
position ON.
• Turn the volume controller
VOLUME
d
to a medium position.
To Next Page
Loading...
