Silvercrest KM 250 B1 - Working with Attachments

GB
│
7 ■
KM 250 B1
5) Start chopping by pressing the ON button .
Press OFF/PULSE button  once when all the
ingredients have been chopped and you want
to stop the appliance.
If you would like to continue to process the
ingredients using the PULSE function, press
the OFF/PULSE button  several times in
succession until the ingredients are sufficiently
chopped.
If ingredients stick to the sides of the bowl  or the
blades:
– Switch the appliance off.
– Remove the lid .
– Remove the ingredients from the cutting
blades  and the inside using a dough
scraper or a spoon.
– Close the lid .
– Restart the appliance.
NOTE
► Only process meat that is boneless!
► Do not allow the appliance to operate for
long periods when chopping (hard) cheese.
Otherwise the cheese will become too hot,
start to melt and clump.
► If you wish to add ingredients during the cut-
ting process, add them via the feed tube !
The appliance stops if the lid  is opened!
Do not exceed the maximum quantities speci-
fied in the table when adding ingredients!
Working with the food processor
You can grate or slice food using the processor’s
attachments -/3.
1) Select the required attachment and assemble
everything as described in the chapter “Assem-
bling the appliance”.
2) Remove the pusher  from the feed tube .
3) Cut the food into pieces that will easily fit into
the feed tube .
4) Start grating/slicing by pressing the ON
button .
5) Then gradually add the food. Push the food in
using the pusher  without applying pressure.
Do not exceed the quantities specified in the follow-
ing table.
INGREDIENT SLICER ATTACHMENT
Apples/carrots max. 350 g
Cucumber max. 1.5
Potatoes max. 350 g
Onions max. 200 g
INGREDIENT GRATER ATTACHMENT
Apples/carrots max. 350 g
Parmesan max. 150 g
Potatoes max. 350 g
Hard cheese (e.g.
mature Gouda)
max. 200 g