Silvercrest KM 250 B1 - Before First Use; Assembling the Appliance; Cutting Blades Assembly

GB
│
5 ■
KM 250 B1
Before first use
■ Remove all packaging materials from the appli-
ance.
■ Clean the appliance as described in the section
“Cleaning and care”.
■ Ensure that all parts are completely dry before
operating the appliance.
Assembling the appliance
NOTE
► The appliance will not start until the bowl 
and the lid  are correctly attached.
1) Place the motor unit  on a flat surface so
that the sucker feet can attach firmly and the
appliance stands firmly in place.
2) Place the bowl  onto the motor unit 
so that the arrow
on the bowl  points
towards the open lock symbol
on the
motor unit . Then turn the bowl  until the
arrow points to the closed lock symbol
and the bowl  clicks into place.
If you want to work with the cutting blades ,
assemble the appliance as described in the section
“Cutting blades”.
If you want to work with the food processing at-
tachments, assemble the appliance as described
in the section “Food processing attachments”.
Cutting blades
1) Place the cutting blades  onto the drive
shaft . The flattened side of the drive shaft 
must correctly fit into the take up of the cutting
blades . Otherwise the cutting blades 
cannot be properly attached.
2) Place the lid  onto the bowl  so that the
arrow
on the lid  coincides with the
arrow and the opened lock symbol
on the bowl .
3) Turn the lid until the arrow
on the lid 
points to the arrow
and the closed lock
symbol
on the bowl .
4) Place the pusher  into the feed tube .
5) Insert the plug into a mains power socket.
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the appliance, never insert
or place your hands or any foreign objects into the feed tube.
► Do not change accessories unless the drive is stationary and the
mixer is unplugged from the power supply! The appliance will run on
for a short time after being switched off!
► Never leave the appliance unattended!
► Before changing accessories or additional parts that are in motion
during operation, the appliance must be switched off and disconnected
from mains power.