Silvercrest SAS 7.4 LI B3 - Cleaning

GB
│
IE
│
11 ■
SAS 7.4 LI B3
NOTE
► If you carry the appliance horizontally or with the wet suction nozzle
1
pointing upwards, it is possible that liquid can leak out:
3) To switch the appliance on, slide the on/off switch 6 forwards. The charge
indicator lamp 7 lights up green.
4) When you have finished using the appliance, slide the on/off switch
6 to
the rear.
NOTE
► Place the handheld vacuum cleaner in the wall bracket
3 and start the
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp 7 flashes green.
Cleaning
To achieve the best results, empty the dirt container q and clean the dust filter 0
after every use.
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container
q, press the release button 8 and remove the
dirt container q.
2) Remove the dust filter
0 from the dirt container q by reaching into the
opening of the dust filter 0 and pulling it out.
3) Empty the dirt container
q.
4) Pull the dust filter bag
9 with its holder out of the dust filter 0.
5) Rinse the dust filter bag
9 out in cold water and wait until it is completely
dry before reinserting it into the dust filter 0. Do not dry it with hot air.