EasyManuals Logo

Silvercrest SAS 7.4 LI D3 Short Manual

Silvercrest SAS 7.4 LI D3
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
10 
GB
IE
SAS 7.4 LI D3
Important: The charge indicator lamp 7 lights up green once the
handheld vacuum cleaner is charged enough to vacuum again. This does
not mean that all the batteries are completely charged. When the charge
indicator lamp 7 lights up green, the batteries are charged to around 80%.
When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter
4.
Do not recharge the batteries again until the handheld vacuum cleaner's suc-
tion power becomes appreciably weaker and the charge indicator
lamp
7 flashes green.
NOTE
If the battery is completely discharged, the appliance switches off and
the charge indicator lamp
7 flashes green/red alternately for approx.
60 seconds. Start charging the appliance.
The handheld vacuum cleaner can also be charged directly via the mains
adapter 4. To do this, remove the barrel plug 5 with a slight twist from
the wall bracket 3 and the cable from the cable routing. Insert the barrel
plug 5 into the socket on the handheld vacuum cleaner.
Operation
CAUTION!
The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
The appliance is not protected against splashes. You should therefore only
vacuum liquid up until the dirt container
q is filled to the MAX mark!
NOTICES
Make certain that the dust filter
0 is always inserted before using the
appliance.
1) Remove the handheld vacuum cleaner from the wall bracket
3 or, if you are
not using the wall bracket 3 remove the barrel plug 5 from the socket.
2) If required, place the appropriate nozzle in the suction opening:
the crevice nozzle
2, to clean narrow and difficult to reach locations.
the wet suction nozzle 1 to vacuum up liquids.
3) To switch the appliance on, slide the on/off switch
6 forwards. The charge
indicator lamp 7 lights up green.
4) When you have finished using the appliance, slide the on/off switch
6 to
the rear.

Table of Contents

Other manuals for Silvercrest SAS 7.4 LI D3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SAS 7.4 LI D3 and is the answer not in the manual?

Silvercrest SAS 7.4 LI D3 Specifications

General IconGeneral
BrandSilvercrest
ModelSAS 7.4 LI D3
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals