• To switch the device off, press and hold the multi-function button 7 for about
3 seconds. A long, low signal tone will be heard and the LED status display 6
extinguishes.
• Position the hands-free appliance and the mobile telephone so that they are
not more than 1 metre away from each other.
• Press and hold down the multi-function button 7 for 6 seconds until, after
3 seconds a short, high signal tone and after a further 3 seconds a succes-
sion of low and high signal tones are heard. The LED status display 6 lights
up constantly and the hands-free equipment is now in the coupling mode.
• Select the hands-free provision „Car Kit“ from the list of available appliances
for the mobile telephone.
• Enter in the pre-programmed passcode "9999" and then confirm it, which
couples the appliances with each other. You will hear a long high signal tone
and the LED status indicator 6 blinks every 3 seconds.
• You can now use the hands-free appliance.
Note:
When using the latest mobile phones, (Smartphones) those that are equipped
with Bluetooth 2.0 or a more modern version, it is possible that the pass code
"9999" need not be entered. If the coupling is not completed within 2 minutes,
the hands-free appliance switches itself off. The LED status display 6 extinguis-
hes and you will hear a long and deep signal tone. With some mobile telepho-
nes it is possible that coupling does not automatically take place. In this case
coupling must be carried out additionally on the mobile telephone. The LED status
display 6 blinks twice every 3 seconds until this has been carried out. Further in-
formation can be found in your mobile telephone’s operating instructions.
10
IB_69169_SBTF10B2_GB.qxd 29.09.2011 10:22 Uhr Seite 10
To Next Page
Loading...
Need help?
General
