Silvercrest SCAA 5.00 A1 User Manual

SilverCrest SCAA 5.00 A1
22 - English
Charging the Battery
It is possible to recharge the camcorder battery pack via the USB power of a computer. To
do this, you will need the USB cable supplied.
Insert the battery pack as described above into the camcorder.
Use the USB cable to connect the camcorder to an available USB port on a computer. Insert
the small plug of the supplied USB cable into the USB/charge port of your camcorder [13]
and the large plug into a USB port on your computer.
You can keep the camcorder powered off while charging. Press and hold the On/Off/Mode
button [2] for three seconds to switch the camcorder off.
The status LED [6] flashes orange during charging. When the charging process is complete,
the status LED [6] goes out.
Some computers do not supply USB power while they are turned off. If
the camcorder does not charge, make sure your computer is switched on.

Silvercrest SCAA 5.00 A1 Specifications

General

Brand	Silvercrest
Model	SCAA 5.00 A1
Category	Action Cameras
Language	English