SDRB 1000 B1
GB
│
IE
│
NI
│
CY │ 7 ■
CAUTION
► Always remove the plug 7 from the power
socket before filling the appliance! There is a
risk of electric shock!
♦ Remove the water tank 1 by sliding back the
release 4 of the water tank 1 until you can lift
the water tank 1 up. Grip the water tank 1
by the protruding gripping aids with your thumb
and index finger and lift it up vertically. The tem-
perature control 3 stays on the appliance and
is not removed along with the water tank.
♦ Open the filler opening 2 in the water tank 1.
♦ Use the measuring cup t to fill the water tank 1
with water to the "Max" marking.
♦ Close the filler opening 2 in the water tank 1.
Ensure that the collar in the filler opening 2
locks into the notch on the lid. This means that
the water tank 1 is properly closed.
♦ Replace the water tank 1 onto the appliance.
The water tank 1 must audibly click into the
release of the water tank 4.
Attaching/removing the brush
extension
CAUTION
► Never remove or attach the brush extension w
while the appliance is hot.
Risk of burns!
♦ To use the steam and brush functions, please at-
tach the brush extension w to the steam brush.
♦ To do this, push the brush extension w onto
the appliance along the guide aid until it is fully
attached. The release of the brush extension q
must click into place audibly.
♦ To use the ironing function, please remove the
brush extension w from the steam brush.
♦ To do this, push the release q downwards and
pull the brush extension w off the appliance.
Steam brush function
♦ Attach the brush extension w to the appliance.
It must audibly click into the release of the brush
extension q.
♦ Insert the plug 7 into a properly installed and
grounded wall socket.
♦ To produce steam, set the temperature control 3
to ••• or higher. The heat-up indicator lamp 5
lights up. As soon as the selected temperature
has been reached, the heat-up indicator lamp 5
goes out.
NOTE
► To use the steam burst function, set the tem-
perature control 3 to ••• or higher.
Lower temperatures are insufficient for pro-
ducing a burst of steam.
♦ You can now produce a burst of steam by press-
ing the steam burst button 8.
NOTE
► To produce the first burst of steam after heat-
ing the appliance, you may have to press the
steam burst button 8 several times in a row.
The appliance is now ready for use.
CAUTION
► The steam brush can be used with any piece
of clothing. Be careful when treating heat-
sensitive textiles such as synthetics, polyamide
or artificial silk. Before treating such materials,
first process a small test patch in an invisible
spot (inside of the seam) to ensure that the hot
steam does not damage the material. Do not
apply the hot ironing sole 0 to these materi-
als directly. Only use the steam burst function.
IB_368338_SDRB1000B1_LB6_GB-IE-NI-CY.indb 7 19.01.2021 15:45:39
To Next Page
Loading...
Need help?
General
