Silvercrest SFG 8000 B2 - Charger Cradle; 9 Before You Start; Inserting the Rechargeable;Conventional Batteries

SilverCrest SFG 8000 B2
English - 15
26 Transmission icon (TX)
27 Scan icon
8.3. Charger cradle
28 Power adapter socket
29 Battery level indicator
30 Charging contacts
9. Before you start
9.1. Inserting the rechargeable/conventional batteries
(The figure is representational)
 If necessary, remove the belt clip (see the chapter “Removing the belt clip”).
 Press the ribbed area of the battery compartment cover and slide it downwards. Then lift the battery
compartment cover upwards.
 Insert three AAA-sized batteries/rechargeable batteries into the battery compartment by respecting the
correct polarity. Note the + and – icons on the batteries and inside the battery compartment.
 Close the battery compartment. Insert the battery compartment cover into the corresponding notch on
the radio transceiver housing and then slide the battery compartment cover upwards until it clicks into
place.
 Replace the belt clip (see “Installing the belt clip”).