Silvercrest SFK 16 A1 User Manual

Wireless Doorbell SFK 16 A1
English - 19
Mounting the Receiver
- Drill one 5mm hole at the desired position
on the wall.
- Insert one of the supplied rawlplugs into
this hole.
- Screw one of the supplied screws into the
rawlplug until its head is approx. 2mm away
from the wall.
- Place the receiver onto the screw head.
The wall-mounting hole located at the back
of the housing must completely fit over the
screw head. By pulling it down carefully the
receiver clicks into place on the screw
head.
Filling out the Name Label
Remove the transparent plastic cover from the
receiver. Underneath you can write on the name
label (7). The package contains 5 labels for
future replacement. Replace the plastic cover by
pushing it onto the transmitter housing.

Silvercrest SFK 16 A1 Specifications

General

Brand	Silvercrest
Model	SFK 16 A1
Category	Intercom System
Language	English