Silvercrest SFR 3.7 B2 - Cleaning and Care; Cleaning the Spray Bottle; Washing the Microfibre Cover; Cleaning the Appliance

GB
│
7 ■
SFR 3.7 B2
■ To charge the appliance, connect the charger 0
to a mains socket and insert the connecting jack .
into the charging socket  on the motor unit .
The indicator light  lights up red.
When the appliance is fully charged, the indicator
light  lights up green.
NOTE
► Only recharge the batteries when the suction
power of the appliance is noticeably weaker
and the red indicator light  is flashing red.
Cleaning and care
DANGER – ELECTRIC SHOCK!
► Prior to cleaning, disconnect the appliance
from the charger 0! Risk of electric shock!
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
Cleaning the spray bottle
■ Open the spray bottle and empty contents.
Remove the microfibre cover 6.
Wipe the components of the spray bottle with
a damp cloth; if necessary, use a little mild deter-
gent on the cloth.
Washing the microfibre cover
The microfibre cover 6 can be machine-
washed at 60°C. Do not use any fabric
conditioner as this significantly reduces the
cleaning power of the microfibres.
Do not bleach the microfibre cover 6!
Do not tumble dry the microfibre cover 6!
Do not iron the microfibre cover 6!
Material: 85% polyester / 15% cotton
Cleaning the appliance
For thorough cleaning, disassemble the appliance:
1) Press the ridged area on the underside of
vacuum attachment  and pull the vacuum
attachment  off the appliance. Clean the
vacuum attachment  with a damp cloth. If
required, use some mild detergent on the cloth.
2) Press the release button  and remove the dirt
container  from the motor unit .
Turn the blue nozzle  at the top end of the dirt
container  slightly anticlockwise and lift it off.
Now you can pull the blue rod downwards out of
the dirt container .
Rinse the dirt container  with fresh water and, if
necessary, with a mild detergent.
3) Wipe the motor unit  off with a damp cloth.
If required, use some mild detergent on the
cloth. Dry the motor unit .
4) Then reassemble the appliance:
– Push the blue rod back into the dirt container .
Make sure that you insert the blue rod correctly:
the slanting side of the blue rod must
be aligned with the slanted side of the dirt
container :