SFR 3 A1
GB
│
IE
│
NI
│
9 ■
– “ ” for medium-sized bobbles and textiles with
moderate structure (medium distance to the cutter
knives),
– „
“ for small lint/bobbles and fine textiles (small
distance to the cutter knives)
– Remove the spacer 5, only for very fine lint (virtually
no spacing to the cutter knives).
3) Push the On/Off switch/Speed switch 1 to the
required speed level.
We recommend that you start working at speed level 1.
If the results are satisfactory and you feel comfortable
handling the appliance then you can switch up to
speed level 2.
4) Guide the shaver foil 4 lightly and without pres-sure
over the material. The fluff and bobbles will be shaved
off and collected in the fluff collector 3.
5) When you want to stop, push the On/Off switch/
Speed switch 1 back to speed level 0.
Note: (1) This appliance is equipped with a safety
cut-out. The appliance switches off automatically, when
you turn off the shaver foil 4. (2) Empty the fluff col-
lector 3 regularly. If the fluff collector 3 is overfilled,
the cutting blades will work more slowly even though
the batteries are not yet weak.
IB_449407_SFR3A1_LB6.indb 9 19.09.2023 11:32:17
To Next Page
Loading...
