To Next Page

To Previous Page

SFS 52 B2

■ 14

│

Selecting the ringer melody

There are 52 diﬀerent ringer melodies stored in the

appliance.

♦ Press the melody select button

.

♦ Stop the selection when you hear the desired

melody. The appliance will use the last-played

melody.

NOTE

► If you remove the receiver from the mains socket,

the set melody remains saved for approximately

40 seconds. After this time, you need to set your

desired melody anew.

Synchronising the sender and receiver

The transmitter and receiver of this wireless doorbell

system can communicate with each other via a num-

ber of diﬀerent codings. This means that you can

operate up to 5 transmitters with one receiver. In ad-

dition, you can extend the wireless doorbell system

with any number of receivers. This is only possible if

the sender and receiver within a system are working

on the same frequency, however. For this, you must

synchronise the appliances as follows:

♦ Press the synchronisation button

 on the

receiver.

♦ Now press the ringer button  on the transmitter.

Silvercrest SFS 52 B2 Operating Instructions

Other manuals for Silvercrest SFS 52 B2