SHAZ 22.2 F7
GB
│
IE
│
23 ■
5) Rinse the EPA filter 5 and the stainless steel filter 6 under cold or luke-
warm water. Allow the EPA filter 5 and the stainless steel filter 6 to air dry
completely before putting them back into the dust container 7 (see Fig. 22).
Fig. 22
6) Insert the stainless steel filter
6 into the dust container 7 and push it all
the way down (see Fig. 23). Pay attention to the different sized locks on the
stainless steel filter 6. The stainless steel filter 6 can only be inserted into
the dust container 7 in one position due to these locks.
Fig. 23
To Next Page
Loading...
