Silvercrest SHBR 560 A1

Questions and Answers

G
garciaamyAug 13, 2025
How to fix the rotary brush 6 if it is not turning on Silvercrest Vacuum Cleaner?
- R
  Robert LiAug 13, 2025
  If the rotary brush on your Silvercrest Vacuum Cleaner isn't turning, first switch off the appliance and unplug it. Ensure the rotary brush is correctly fitted onto the foot section. Also, check if the rotary brush is blocked. If it is, remove the plug, take off the splash guard and rotary brush to clear any blockage, then reattach them before switching the appliance back on.
S
Sara JohnstonAug 17, 2025
Why my Silvercrest SHBR 560 A1 Vacuum Cleaner will not switch on?
- N
  Nathan YoungAug 17, 2025
  If your Silvercrest Vacuum Cleaner won't turn on, there might be several reasons. First, ensure the appliance is properly connected to the power supply and switched on by pressing the hard floor or carpet switch. Check that the plug is fully inserted into the mains power socket and that the mains socket is supplying power by checking the house mains fuse. Also, empty the waste water tank if it's full. If none of these steps work, the appliance may be defective, and you should switch it off, pull out the mains plug.
A
Ashley JacobsAug 21, 2025
Why is the suction power too weak on my Silvercrest Vacuum Cleaner?
- A
  austinstewartAug 21, 2025
  If the suction power of your Silvercrest Vacuum Cleaner is too weak, check these potential causes: * Ensure the fresh and waste water tanks are correctly fitted to the appliance. * Empty the waste water tank if it is full. * Make sure the splash guard is properly fitted onto the foot section. * Clean the suction channel to remove any blockages. * Remove and clean the dirt filter.
C
Christian LaneAug 25, 2025
What to do if my Silvercrest Vacuum Cleaner is not dispensing enough cleaning solution?
- F
  fbonillaAug 25, 2025
  If your Silvercrest Vacuum Cleaner isn't dispensing enough cleaning solution, make sure the fresh water tank is filled. Check that the fresh water tank is closed properly. Before each use, press and hold the cleaning solution switch for about 10 seconds to prime the rotary brush. Ensure you continuously press the cleaning solution switch while in use. Also, check that the splash guard is properly fitted.
I
iwalkerAug 28, 2025
What to do if my Silvercrest SHBR 560 A1 Vacuum Cleaner is leaking water?
- T
  Thomas GilbertAug 28, 2025
  If water is leaking from your Silvercrest Vacuum Cleaner, the fresh water tank might not be closed properly. Remove the fresh water tank and tighten the lid to ensure a proper seal.
W
William RobertsonSep 1, 2025
Why my Silvercrest Vacuum Cleaner won't turn on?
- V
  vdixonSep 1, 2025
  Your Silvercrest Vacuum Cleaner might not be turning on for several reasons. Ensure the appliance is correctly connected to the power supply and switched on using the hard floor switch or the carpet switch. Check that the plug is fully inserted into the mains power socket and that the socket is supplying power by checking the house mains fuse. Also, empty the waste water tank if it's full. If none of these steps work, the appliance may be defective, and you should switch it off and pull out the mains plug.
M
monica40Sep 5, 2025
Why is the suction power of my Silvercrest Vacuum Cleaner too weak?
- S
  Sean WilliamsSep 5, 2025
  Weak suction power in your Silvercrest Vacuum Cleaner can be due to several factors. Make sure that the fresh and waste water tanks are properly fitted to the appliance. Empty the waste water tank if it is full. Ensure the splash guard is correctly fitted onto the foot section. Check for and clear any blockages in the suction channel. Lastly, remove and clean the dirt filter.
J
Justin DuranSep 8, 2025
How to fix a Silvercrest SHBR 560 A1 when the rotary brush is not turning?
- H
  hallmatthewSep 9, 2025
  If the rotary brush on your Silvercrest Vacuum Cleaner isn't turning, switch off the appliance and unplug it. Ensure the rotary brush is properly fitted onto the foot section. Also, check for any blockages; remove the splash guard and rotary brush to clear them. Then, reattach the rotary brush and splash guard, plug the appliance back in, and switch it on.

Summary

Safety Information Overview

Risk of Electrical Shock

Outlines critical safety measures to prevent electric shock during use.

Safety Warnings and Risks

Electrical and Injury Risks

Provides further safety advice regarding water, electrical hazards, and potential injuries.

Property Damage Prevention

Attention! Property Damage

Highlights precautions to prevent damage to the appliance or property.

Package Contents and Initial Assembly

Assembling the Appliance

Step-by-step guide on how to assemble the main components of the appliance.

Fresh Water Tank Filling

Water and Solution Levels

Guides on filling the fresh water tank with water or cleaning solution for different area sizes.

General Operation Handling

Cleaning Hard Floors

Procedures for operating the appliance to clean hard floors, including switch operations.

Carpet Cleaning Procedure

Cleaning Carpets

Instructions for operating the appliance to clean carpets, including switch operations.

Cleaning and Maintenance Procedures

Cleaning the Waste Water Tank

Step-by-step guide on how to empty and clean the waste water tank.

Appliance Self-Cleaning Function

Operating the Self-Cleaning Cycle

Dirt Filter Replacement

Troubleshooting Common Issues

Appliance Not Switching On

Solutions for common issues when the appliance fails to power on.

Troubleshooting Operational Problems

Dispensing & Brush Rotation Issues

Silvercrest SHBR 560 A1 Specifications

General

Type	Handheld vacuum cleaner
Dustbin capacity	0.6 liters
Battery capacity	2200 mAh
Charging time	4-5 hours
Operating time	Up to 30 minutes
Dust capacity	0.6 liters
Weight	1.5 kg
Noise level	75 dB
Filter type	Washable HEPA filter
Cord length	Cordless