Silvercrest SHBR 560 A1 - Troubleshooting Common Issues; Appliance Not Switching On

■ 22
│
GB
│
IE
│
NI
SHBR 560 A1
Troubleshooting
The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Cause Remedy
The appliance
will not switch
on.
The appliance is not
switched on.
Make sure that the appliance is properly
connected to the power supply.
Press the hard floor switch
r or the carpet
switch
e to switch the appliance on.
The plug is not
plugged in.
Insert the plug into the mains power socket.
The mains socket is
not supplying any
power.
Check the house mains fuse.
The waste water
tank
2 is full.
Empty the waste water tank
2 (see section
Cleaning the waste water tank).
The appliance is
defective.
Switch the appliance off and pull out the mains
plug.
Contact Customer Service (see section Service).
The suction
power is too
weak.
The fresh and waste
water tanks
q/2
are not properly fitted.
Attach the fresh and waste water tanks
q/2
properly to the appliance (see sections
Filling the fresh water tank and Cleaning the
waste water tank).
The waste water tank
2 is full.
Empty the waste water tank
2 (see section
Cleaning the waste water tank).
The splash guard
7
is not fitted properly.
Fit the splash guard 7 properly onto the foot
section 3 (see section Manual cleaning).
The suction channel is
blocked.
Clean the suction channel and remove the
blockage (see sections Self-cleaning function
and Manual cleaning).
The dirt filter
0 is
blocked.
Remove the dirt filter 0 and clean it (see sec-
tion Cleaning the waste water tank).
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 22 09.06.2020 14:04:57