GB
│
IE
│
NI
│
11 ■
SHBR 560 A1
Handling and operation
ATTENTION! PROPERTY DAMAGE!
► While working with the appliance, make sure that the rotary brush
6 does
not get blocked by loose objects lying around on the floor or by carpet
edges. These can damage the rotary brush
6 and stop it from working
properly.
Cleaning hard floors
Once the appliance is assembled and the fresh water tank q is filled with water
and cleaning solution:
Ƈ Unwind the power cable
u completely from the upper and lower cable retainers
z/p. To unwind the power cable u quickly from the cable retainers z/p,
pull the upper cable retainer z out a little way and turn it downwards (see
fig. 12).
Ƈ Insert the plug into the mains power socket.
Ƈ Press the hard floor switch
r to switch the appliance on (see fig. 13).
The LED on the hard floor switch r lights up blue.
Fig. 12 Fig. 13
Ƈ Before each use, press and hold the cleaning solution switch
t for about
10 seconds to add cleaning solution to the rotary brush 6 so that it is ready
for use (see fig. 14). The cleaning solution display w flashes alternately
blue when the cleaning solution switch t is held down (see fig. 15).
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 11 09.06.2020 14:04:54
To Next Page
Loading...
