Silvercrest SHBR 560 A1 - Manual Cleaning

■ 18
│
GB
│
IE
│
NI
SHBR 560 A1
Manual cleaning
For heavier soiling, it is necessary to manually clean the rotary brush 6, the
splash guard
7 and the brush chamber in the foot section 3 of the appliance.
If this occurs, do the following:
Ƈ Make sure that the appliance is not plugged in.
Ƈ Take hold of the top of the splash guard
7 by the edge of the handle (PULL)
and pull it forward to remove it from the foot section 3 (see fig. 33).
Ƈ Take hold of the bracket on the left side of the rotary brush
6 and pull it
upwards to remove the rotary brush from the foot section 3 (see fig. 34).
Fig. 33 Fig. 34
Ƈ Clean the splash guard
7 and the rotary brush 6 in hot running water (see
fig. 35).
Ƈ If the brush chamber is dirty, wipe it out with a damp cloth or rag (see fig. 36).
Fig. 35 Fig. 36
Ƈ Allow the rotary brush
6 and the splash guard 7 to dry completely before
fitting them back onto the appliance (see fig. 37).
Ƈ You can also place the rotary brush
6 upright in the rotary brush holder 5 on
the parking and cleaning station for drying (see Figure 38).
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 18 09.06.2020 14:04:56