Silvercrest SHAZ 22.2 F7 - Cleaning the Rotary Brush

SHAZ 22.2 F7
GB
│
IE
│
25 ■
Cleaning the rotary brush
ATTENTION!
► Only use the appliance with the rotary brush a properly mounted.
1) Remove the floor brush
s from the suction pipe f or from the appliance
(see section Dismantling the appliance). Turn the floor brush
s upside
down.
2) Unlock the rotary brush
a by sliding the rotary brush release o with your
finger towards the symbol (open). Remove the rotary brush holder p
from the floor brush s (see Fig. 26).
1.
2.
Fig. 26
3) Pull the rotary brush
a out of the floor brush s by the bristles. Turn the
rotary brush a slightly to make it easier to remove (see Fig. 27).
Fig. 27