8 GB
or any other liquid and never rinse
this/these under running water.
Do not use the
product while bathing.
For additional protection, the
installation of a residual current
device (RCD) having a rated
residual operating current not
exceeding 30 mA is advisable
in the electrical circuit supplying
the bathroom. Ask your installer
for advice.
Remove the USB Type A to C
cable
16
from the power supply
(not included in delivery)
- if a malfunction occurs,
- before you clean the product,
-
if you have not used the product
for a long time,
- during a thunderstorm and
- after each use.
When doing so, remove the USB
Type A connector
15
directly from
the socket and do not pull it out
using the USB Type A to C ca-
ble
16
.
Avoid risk of injury
Do not change the accessories
while the product is switched o
n.
Do not use the product if you de-
tect any kind of visible, external
damage. Never use a damaged
product.
If liquid gets into the product,
check
before – using the produ
ct
once more.
If you notice that the USB Type
A to C cable
16
, housing or ano-
ther part has become damaged,
the product can no longer be
used.
Repairs should only be carried
out by a specialist. Improper re-
pairs may result in considerable
danger to the user. This will also
make any warranty claims void.
Do not use defective attachm
ents
with the product as these could
have sharp corners.
Defective components must al-
ways be replaced with original
spare parts. Only by using orig-
inal spare parts can you ensure
t
hat safety requirements are m
et.
For loading connect the USB Type
A to C cable
16
to a power sup-
ply which is well within reach.
Never use the product unsuper-
vised and only use it in accord-
ance with the information stated
on the type plate.
Connect the USB Type A to C
cable
16
to the product before
inserting it into the power supply.
To Next Page