24
11.2 Error code in display
It is not possible to select
a speed higher than 3.
A temperature is currently set Set the temperature to 0
Display Cause Solution
E3 Blender jug 6 is too full Remove some of the contents
The lid of the blender jug 6
is not properly closed
Close the lid properly (see
“7.5 Positioning the lid of the
blender jug” on page 13)
HHH The blender jug 6 is not
correctly positioned in the
base unit 17
Position the blender jug 6
correctly (see
“7.3 Positioning the blender
jug” on page 12)
The blender jug 6 was
removed while the appliance
was in operation
Stop the appliance before
removing the blender jug 6
(see “6.7 Starting and
stopping the appliance” on
page 10)
LLL Fault in the logic circuitry Contact the Service Centre
(see “Service Centre” on
page 26)
Selected temperature has
been reached (see
“6.4 Setting the
temperature” on page 9)
None required
Malfunction Cause Solution
RP93471 Küchenmaschine mit Heizung LB6 Seite 24 Donnerstag, 14. August 2014 3:38 15
To Next Page
Loading...
