9
GB
- When emptying the blender jug, ensure not to touch the blades
of the blade assembly.
- When removing and inserting the blade assembly ensure not to
touch the blades.
~
During the turbo function, ensure that no hot ingredients are in the
blender jug. These could be ejected and may cause scalding.
~
After being switched off, the blade assembly and the mixer attach-
ment will continue to rotate for a while. Therefore, the automatic
lock provides protection against the opening of the lid prior to the
standstill. Especially liquid food may move even after the standstill
of the blade assembly. Do not open the lid until the food is at a
standstill.
~
This device is not intended to be operated using an external timer
clock or a separate remote control system.
~
If the power cable of this device should become damaged, it must
be replaced by the manufacturer, the manufacturer's customer ser-
vice department or a similarly qualified specialist, in order to avoid
any hazards.
~
Prior to replacement of parts or attachments which move when in
operation, the device must be switched off and disconnected from
the mains.
~
Make sure that no liquid overflows onto the plug connections of the
device.
~
Remember that the surface of the heating element remains hot after
use.
~
This device is equally intended for use in the home and in applica-
tions similar to the home, such as for example...
… in kitchens for staff in shops, offices and other commercial set-
tings;
… on agricultural properties;
… by customers in hotels, motels and other residential facilities;
… in bed-and-breakfast establishments.
~
Please take note of the chapter on cleaning (see “Cleaning and ser-
vicing the device” on page 28).
__317553_MC_plus_GR_CY.book Seite 9 Freitag, 12. April 2019 10:00 10
To Next Page
Loading...
