Silvercrest SKMK 1200 D4 - 16.2 Error messages on the display

33
GB
Liquid escapes at the
lid34 of the blender
jug5
Seal33 has not been inserted
correctly.
Insert seal33 correctly (see
“Cleaning, checking and replac-
ing seals” on page 29).
Seal33 is defective.
Insert new seal33 (see “Clean-
ing, checking and replacing seals”
on page 29).
No temperature can be
set.
A speed setting 4 - 10 was se-
lected.
Select speed setting 0 - 3 (see “Set-
ting the speed” on page 17)
Parts of the device are
discoloured.
Certain food or spices (e.g.
curry) may discolour plastic.
This is not a defect with the de-
vice
Remedy unnecessary, since not
harmful to health.
A speed setting ex-
ceeding 3 cannot be
selected.
A temperature has been set. Set temperature to 0.
The device stops after
15 minutes.
A speed setting 7 - 10 was se-
lected. At these speed set-
tings, the device will function
for a maximum of 15 minutes
without a pause.
Select speed setting 0 - 6 (see “Set-
ting the speed” on page 17).
When switching on,
the set time is automat-
ically set to 15:00.
The lid34 / the deep
steamer basket3 can-
not be opened.
The electronic lock is activated
(see “Automatic lock” on
page 14).
Stop the device and wait until the
LED 15 has gone out before
opening the lid34 / the deep
steamer basket3.
Did you try to open the
lid34 / the deep steamer
basket3 while the LED 15
was lit?
Possibly, the electronic lock is
blocked.
Turn the lid
34 /
the deep steamer
basket3 with both hands clock-
wise until it is completely closed
(see “Put on the lid of the blender
jug” on page 21) or (see “Prepa-
ration of the steamer inserts” on
page 24).
Malfunction Cause Remedy
GB_317553_MC_plus_GR_CY_.fm Seite 33 Donnerstag, 18. April 2019 9:12 09