Overview of equipment
Front side of the receiver
Rear side of the receiver
Remote control
Overview of equipment
Front side of the receiver
1 – Infrared sensor for the signal of the remote control
2 LED STBY LED is illuminated if the receiver is in standby mode
3 LED ON LED is illuminated if the receiver is switched on
4 CH – Switches to the next lower channel location
Cursor moves down
5 CH + Switches to the next higher channel location
Cursor moves up
6 STANDBY Switches on and switches to the standby mode.
The default settings will be restored if you keep this key
pressed for more than 10 seconds.
Caution! By doing this, your personal settings will be
deleted.
Rear side of the receiver
1 LNB IN LNB connection for the antenna cable
2 IF OUT LNB connection for a second satellite receiver
3 VCR SCART connection for the video set
4 TV SCART connection for the TV set
5 100 – 240 V~ Mains connection
50/60 Hz, 20 W
6 ON/OFF Mains switch
7 RS 232 Serial port
8 COAXIAL Digital coaxial audio output
9 AUDIO L Left stereo audio connection
10 AUDIO R Right stereo audio connection
#
Faulty-Description:
GUARANTEE
Sender please use block-writing in boxes with CAPITAL LETTERS
Surname
Firstname
Street
Postcode and city
Telefon no. with areacode
Signature of buyer
PLEASE CUT THIS CARD AND ENCLOSE IT TO THE RETURNING GOOD
COMAG
Service Centre
Unit 1 Longs
Industrial Estate
Englands Lane
Gorleston Great
Yarmouth
Norfolk NR31 6BE
Service-Hotline:
00 44 (0) 8708 900137
E-mail:
info@comag-ag.co.uk
Model / Type: SL 35
•
•
f
r
o
m
p
u
r
c
h
a
s
e
-
d
a
t
e
•
•
•
•
3
6
m
o
n
t
h
s
•
•
Guarantee