EasyManua.ls Logo

Silvercrest SMA 500 A1 - Speaker Operation

Silvercrest SMA 500 A1
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 
GB
IE
NI SMA 500 A1
NOTE
The operating LED
3
illuminates in red during the
charging procedure and in blue after the battery has
been fully charged.
The maximum charging time is about 4 hours, and
allows music to be played for up to 8 hours at a
volume level of 50%.
As soon as the operating LED
3
illuminates in red,
the battery is empty and requires charging.
Speaker operation
Completely unwind the speaker cable
8
from the
cable storage (underside of device).
Connect the 3.5 mm jackplug of the speaker cable
8
to your playback device.
Switch the speaker on by moving the On/Off
switch
4
to the ON position. The operating
LED
3
illuminates in blue.
Switch on your player and select the required volume
using the volume control
5
.
To obtain a rich bass tone, move the BASS switch
6
to the ON position.
To switch the speaker off again, move the On/Off
switch
4
to the OFF position. The operating LED
3
goes out.

Table of Contents

Related product manuals