GB
│
IE
│
NI
│
CY
│
9 ■
SMAS 600 A1
♦ Remove the container 4 from the base 7 and fill it with milk. Add enough
milk to reach the MIN mark (= 75 ml) inside the container 4. However,
you should never fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will spill over:
– up to the lower MAX marking
(= 150 ml), if you want to froth milk
– up to the upper MAX marking
(= 300 ml), if you only want to heat
the milk
♦ Place the container 4 on the base 7.
♦ Put the lid 1 on.
♦ Use the "FUNCTION" button 5 to select the appropriate programme:
– Press once = heat milk with foamy froth
– Press twice = heat milk with compact froth
– Press three times = heat milk with only a little froth
– Press four times = froth milk cold
The control lamp 9 for the relevant programme lights up
(red = hot, blue = cold).
♦ Press the "ON/OFF" 6 button to start the selected programme.
The appliance starts the preparation process.
♦ The appliance switches off automatically at the end of the programme, the
control lamp 9 goes off.
If you wish to stop the preparation process before completion, press the
"ON/OFF" button 6 or take the appliance off the base 7. You will have
to reselect the programme when you continue the preparation process.
♦ Remove the lid 1 and pour the milk and/or the milk froth into the desired
container.
♦ Allow the appliance to cool down for about 2 minutes before you froth up
another portion of milk. Otherwise the appliance will automatically trigger the
overheating protection after five successive cycles. The control lamps 9 flash
and you cannot make any entries. The appliance is ready for use again after
around five minutes.
To Next Page
Loading...
