GB
│
IE
│
NI
│
CY
│
11 ■
SMAS 600 A1
Clean the container 4 immediately after it has cooled down each time you use it
to prevent the milk residue from drying on. Proceed as follows:
♦ For initial basic cleaning, fill the container 4 with water and, if required, a
little detergent (the whisk 3 is inserted). While doing so, note the MIN and
MAX - markings
(= 300 ml).
♦ Start the appliance so that the whisk 3 swirls through the water for a while.
Afterwards, rinse the appliance out with clean water.
For a thorough cleaning and for the initial cleaning, proceed as follows:
♦ Remove the whisk 3 from the appliance and clean the inside of the
appliance with warm water and mild detergent if required. Wipe the interior
out with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse out the appliance thoroughly with clean water
and dry it.
♦ Pull the sealing ring 2 off the lid 1 and clean both parts in mild soapy
water. Rinse off detergent residues with fresh water and dry the parts well.
Push the sealing ring 2 back onto the lid 1.
♦ Clean the whisk 3 in mild soapy water and then rinse it thoroughly with
fresh water. Allow it to dry.
♦ Clean all exterior surfaces, the base 7 and the mains cable with a slightly
damp cloth. For stubborn soiling, use a mild detergent on the cloth. Wipe
off any detergent residues using a cloth moistened only with clean water.
Always dry the appliance thoroughly before using it again.
Storage
♦ Allow the appliance cool down completely before putting it into storage.
♦ Wind the power cable around the cable retainer 8 in a clockwise direction.
♦ Store the appliance in a clean and dry location.
To Next Page
Loading...
