Silvercrest SNM 700 A1 - Initial Setup and Use

6
GB
~ Do not put any ingredients with a tem-
perature in excess of 85 °C into the
blender jug.
~ In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blades of the blade
attachment rotate with difficulty or not at
all. Pull out the mains plug and investi-
gate whether there is an obstruction in
the blender jug or whether the contents
are too viscous. Also check whether the
device is assembled correctly.
~ Do not operate the device with empty
blender jugs, as this causes the motor to
overheat and may result in it being
damaged.
~ Only operate the device when a blade
attachment is screwed onto the blender
jug.
~ The device is designed for a maximum
operating time of 60 seconds without in-
terruption. After this, the device must re-
main switched off until it has cooled
down to room temperature.
~ Only use the original accessories.
~ The device (base unit, power cable with
mains plug) is not dishwasher-safe.
~ Do not use any astringent or abrasive
cleaning agents.
~ The device is fitted with non-slip plastic
suction feet. As furniture is coated with
a wide array of varnishes and synthet-
ics, and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.
4. Items supplied
1 base unit1
1 Blender jug large5
(min. 100 ml – max. 800 ml)
1 Blender jug medium6
(min. 100 ml – max. 500 ml)
1 Blender jug small7
(min. 100 ml – max. 200 ml)
1 blade attachment8 (cross blade)
1 blade attachment9 (flat blade)
2 To-Go lid, 1 keep-fresh lid10
1 copy of the user instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
5. How to use
• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see “Cleaning” on page 9)
• Unwind the desired length of cable from
the cable spool3 on the underside of
the device.
• Place the device on a dry, level, non-slip
surface.
__326494_Nutrition Mixer_B7.book Seite 6 Montag, 15. Juli 2019 12:15 12