Silvercrest SPMR 8000 B1 - Searching for CTCSS Code; Searching for DCS Code

SilverCrest SPMR 8000 B1
22 - English
Searching for a CTCSS code
If an active channel is found, press the PTT button [12] to use the found channel. Next you can search for
the CTCSS or DCS code being used.
 Press the Menu
button [6] six times. The indications “SC” and “CTCSS 00”
will flash on the display. The current channel number will also be displayed.
 Press the Up  [10] or Down  [7] button to scan the selected channel.
Once a transmission is detected on the selected channel, its CTCSS code (if any) is detected and
displayed.
Pressing the PTT button [12] will cause the handheld transceiver to use that code and
return to idle mode.
Searching for a DCS code
 Press the Menu button [6] seven times. The indications “SC” and “DCS
00” will flash on the display. The current channel number will also be
displayed.
 Press the Up  [10] or Down  [7] button to scan the selected channel.
Once a transmission is detected on the selected channel, its DCS code (if any) is detected and displayed.
Pressing the PTT button [12] will cause the handheld transceiver to use that code and
return to idle mode.