EasyManua.ls Logo

Silvercrest SPWG 180 A2 - Before First Use; Initial Use

Silvercrest SPWG 180 A2
52 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15 GB/IE
Risk of leakage of batteries /
rechargeable batteries
Avoid extreme environmental
conditions and temperatures,
which could affect batteries /
rechargeable batteries, e.g.
radiators / direct sunlight.
If batteries / rechargeable batter-
ies have leaked, avoid contact
with skin, eyes and mucous mem-
branes with the chemicals! Flush
immediately the affected areas
with fresh water and seek medi
cal
attention!
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries / rechargeable
batteries can cause burns on
contact with the skin. Wear
suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before
inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before first use
Remove all packaging materials from the
product.
Initial use (see Fig. H)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Open the battery compartment
4
at the back
of the product by pushing the battery compart-
ment cover clip
6
on the battery compartment
cover
5
toward the battery compartment
4
and lifting off the battery compartment cover
5
.
3. Remove the insulating strip
7
under the
battery.
4. Reattach the battery compartment cover
5
to
the battery compartment
4
. Be sure to insert
the retaining pin on the battery compartment
cover
5
into the notch on the edge of the
battery compartment
4
.
Firmly press the battery compartment cover
5
into the battery compartment
4
until you hear
it lock into place.

Table of Contents

Related product manuals