EasyManua.ls Logo

Silvercrest SPWS 180 E1 - Battery Leakage and Product Damage Risks; Initial Use and Setup; Inserting and Replacing Batteries

Silvercrest SPWS 180 E1
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 GB
open them. Overheating, fire or
bursting can be the result.
Never throw batteries / recharge-
able batteries into fire or water.
Do not exert mechanical loads to
batteries / rechargeable batteries.
Risk of leakage of batteries /
rechargeable batteries
Avoid extreme environmental
conditions and temperatures,
which could affect batteries /
rechargeable batteries, e.g.
radiators / direct sunlight.
If batteries / rechargeable batter-
ies have leaked, avoid contact
with skin, eyes and mucous mem-
branes with the chemicals! Flush
immediately the affected areas
with fresh water and seek medi
cal
attention!
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries / rechargeable
batteries can cause burns on
contact with the skin. Wear
suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before
inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Initial use
Note: Remove all packaging materials from the
product.
Inserting / replacing the
batteries (see Fig. F)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Open the cover of battery compartment
6
at
the back of the product.
3. Remove the used batteries, if present.
Note: The LC display
1
will show then to
replace the batteries. When standing on the

Table of Contents

Related product manuals