GB
│
IE
│
11 ■
SSKT 900 A1
♦ Fill the inner bowl i with around 0.5 litres of water and place it back inside the
appliance.
♦ Replace the lid 5 in the position it was in when you removed it. Turn the lid 5
anticlockwise by the handle 3 until the stop.
♦ Use the supplied power cord a to connect the mains connection socket 8 with
a properly connected and grounded power socket that supplies the voltage
specifi ed in the section “Technical data”.
♦ Allow the appliance to heat up for about 6 minutes. Proceed as described in the
section “Operation”.
NOTE
►
The fi rst time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue. This is normal and is
completely harmless. Ensure suffi cient ventilation; for example, by opening
a window.
♦ At the end of the cooking phase, the appliance emits 3 beeps. Then pull the plug
of the power cord a out of the mains socket and allow the appliance to cool
down for at least 30 minutes.
♦ Clean the appliance and the inner bowl i again.
Operation
♦ Turn the lid 5 around 25° clockwise by the lid handle 3 to the stop and
remove it upwards. The locking pin 0 must point to the opened lock symbol on
the appliance handle 4 .
♦ Remove the inner bowl i and add the food you wish to cook, together with the
amount of water specifi ed in the following tables, to the inner bowl i.
NOTE
►
The information in the table is intended as a guideline and can vary depen-
ding on the ripeness, size or condition of the food! If necessary, adjust the
cooking time/amount of water/food.
IB_274422_SSKT900A1_IE.indb 11 14.01.16 17:35
To Next Page
Loading...
