Silvercrest SSRM 10 A1 Manual

SilverCrest SSRM 10 A1
English - 15
Switching on / off
Briefly press the "On/Standby" button (6) to switch on the scan
radio. "ON" is indicated briefly on the display (1), followed by
the frequency currently set.
Briefly press the "On/Standby" button (6) again to switch off the
scan radio. "OFF" is indicated briefly on the display (1), followed
by the time currently set.
Setting the volume
You can set the device volume to a value between "00" (mute)
and "15" (maximum volume). The setting upon delivery is "03".
Proceed as follows:
Press the "-" button (2) or "+" button (4) in radio mode to
decrease or increase the volume. The "VOLUME" indicator (21)
also appears on the display.
If the volume reaches level "04", the volume warning symbol
(17) starts to flash on the display. Now you can continue to
increase the volume only if you have confirmed the volume
warning in advance by briefly pressing the "MODE" button (3).
The display indicates the volume level currently set. If no button is
pressed for approx. 3 seconds, the currently tuned frequency
appears on the display again. If the device is set to a value
between "5" and "15" when it is switched off, the scan radio
starts at volume "03" when it is switched on again.

Silvercrest SSRM 10 A1 Specifications

General

Brand	Silvercrest
Model	SSRM 10 A1
Category	Radio
Language	English