EasyManua.ls Logo

Silvercrest SSSES 1.5 A1 - Device Operation and Switching; Operating the Dispenser; Switching Off the Device; Cleaning and Storage

Silvercrest SSSES 1.5 A1
100 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
GB
NOTE: with the initial commissioning, the process must be re-
peated several times until the soap is dispensed.
3. The outflow stops after several seconds or when you remove
your hand. The yellow LED goes out.
4. Hold a hand under the outflow opening again|3, to request
soap once more.
NOTE:
Excess lather at the outflow opening|3 is best scraped off
with a finger at the end of the outflow.
If you want to remove your hand while the soap dispensed,
pull it away downward. Thus, the last soap droplets still end
up in the hand.
Switching off the device
NOTE: switch off the device only when you are not using it for
an extended period of time, e. g. when you are on vacation.
Press the On/Off switch|9 on the back.
The LED|8 lights up briefly in red when you switch it off.
9. Cleaning
CAUTION:
~ Do not use any sharp or abrasive cleaning agents.
Cleaning the device
For cleaning the device, use a soft, moistened cloth.
10. Storage
When you do not want to use the device for an extended period
of time, remove the batteries.

Table of Contents

Related product manuals