Silvercrest STK 36 B2 - Operation Guide; Transmitter;Receiver Synchronization

GB/IE/NI14
Remove the used batteries, if present.
Insert a battery (3 V (direct current), type CR 2032).
The side marked “+” must face upwards.
Fasten the holder
15
and screw
18
of the transmitter back on to the
back of the product.
The transmitter battery compartment with the holder
15
must be in-
stalled by the screw
18
while in use. If the holder
15
is damaged,
stop using the product.
Operation
Synchronising transmitter / receiver
Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchronis-
ing mode.
You can also manually enter synchronising mode by holding the
synchronising button
7
for approx. 3 seconds.
The signal indicator
1
on the receiver will light on.
Press the chime button
11
, the signal indicator
12
on the transmitter
will illuminate once.
The signal indicator
1
on the receiver will then blink. This is to indi-
cate the synchronisation is successful.